Remy Hair Wigs Adhesives & Tapes Info 

How To Apply Your Remy Lace Wig

Most clients like to wear their Remy Lace Wig hair units, for extended amounts of time. The best way to achieve an extended wear is by applying tape & liquid adhesive to your unit. We recommend the following :

1.        Do not cut the lace. First slip your Remy Lace Wig on & make sure that it fits. It should cover all of your hair on your head and/or the area you want the wig to cover, if you are bald.

2.        Cut all of the lace off your Remy Lace Wig unit up to wear the hair starts.

3.        Start with the front hairline. Apply a thin layer of scalp protector to your front hairline. Let it dry 5 minutes.

4.        Apply the tape of your choice along your front hairline. Remember, the wider your tape, the lower your Remy Lace Wig will come down on your forehead. So, If the tape is too wide, cut it lengthwise, so it will be just wide enough to apply your unit.

5.     Now apply a thin layer of your choice of adhesive. Its best to apply the adhesive with a
toothpick, to make sure you are not putting too much adhesive on your skin. If you are using a clear adhesive, let it dry 5 minutes. If you are using a cream colored adhesive, let it dry until the adhesive turns clear. This is also generally about 5 minutes, but can be longer if you put the adhesive on too thick.

6.        Repeat step 5 & let this 2nd layer dry 5 minutes also.

7.        Repeat step 5 again & let this 3rd layer dry 30 seconds.

8.        Now position your unit & start pressing into place starting with the center of the front hairline. You should bring the lace right up to the edge of the glue so they will seamlessly blend together. It's best to do the pressing with a rat tooth comb & not your fingers, to avoid an oil residue from your fingertips.

9.        After you have pressed the Remy Lace Wig in place, using a warm hair dryer, go along the front hairline &blow dry the hairline, while pressing down on the edges with a rat tooth comb, to ensure that the bond is taking place. Spend about 5 minutes blow drying. If you have a hooded dryer, sit under for about 10-15 minutes for an extra tight bond.

10.     Now that the front is finished, wait approx. 30 minutes before you do the back, nape of the neck area, (note: If you sat under the dryer for step 9, you only need to wait an additional 15 minutes, before starting the nape area.)We suggest that you wait to ensure that the front is dry.

11.     For the nape area, repeat the same procedure of steps 2-9, but do it for your nape of neck area. For this step, you will not need to sit under the hooded dryer.